How to clean the dirt inside the laser tubeAfter working for a period of time, there will be a lot of dirt on the wall of the laser tube water casing pipe and the water pipe. This is caused by the long-term use of the laser tube, the dust, the deposition of cutting materials, and the reproduction of

In answer to the requirement from some distributors and partners, hereby we notify the daily maintenance as following:1：The installation of laser tube: Generally the location of laser tube stand shall be at the 1/4 point of the end of laser tube. In the condition of connecting with water cooling sys

CO2 laser tube is made of glass and handmade article, theoretically each laser tube is different. Thus as laser machine manufacturer and distributor, how to choose CO2 laser tube? According to practice and experience, Shanghai Puri Laser Technology Co.,Ltd offer the below suggestions:　　1.To check th

1. Check the laser power test the “L” and “N” pin on the laser power by the multimeter, whether it shows 220V voltage 2. Whether the water flow is unobstructed. The pipes can't be connect inversed. "WATER INLET" connect the water pump 3. Check the water protection(the most possible problem) E

1,Installation RequirementsLaser tube should be Strictly installed according to the installation diagram, it’s equipped with a dedicated power supply, positive pole is with high voltage, and the starting voltage is 24 kV !Adverse consequences caused by failure to installation: inner tube breakdown b